For mass production of products such as LED encapsulation parts, earphone sleeves and eyeglass nose pads, complex material ratios, long curing times and low molding efficiency often slow down production lines and increase production time. A glass-clear liquid silicone rubber has become an "efficiency booster" on production lines with its strengths of 1:1 golden ratio, 5-minute fast curing and moderate viscosity. It enables fast and stable production of transparent products and greatly improves yield rates. Its user-friendliness fully meets industrial production requirements. The two-component A and B are mixed at a 1:1 weight ratio, with no complicated calculations or conversions required. Production workers can operate quickly without professional training, completely eliminating material waste and defective products caused by ratio errors, thus doubling efficiency in the proportioning process. Its curing speed is even more impressive: under processing conditions of 130℃ and 15MPa, full curing is achieved in only 5 minutes. Compared with traditional silicones that take dozens of minutes or even hours, the production cycle is drastically shortened, single-mold efficiency is significantly improved, making it ideal for large-scale batch production. Viscosity of different models is precisely tailored to various production needs, controlled at 50–100 Pa·S with moderate fluidity. After injection, it quickly and evenly fills every fine detail of the mold, whether it is the tiny gaps in LED encapsulation or the ergonomic textures of earphone sleeves and nose pads, ensuring no missing glue or overflow. Molded products feature clean edges and delicate textures without additional grinding or trimming. In addition, the entire series has a uniform density of 1.01 g/cm³, with uniform texture and no impurities after mixing. The linear shrinkage rate after curing is only 2.0–2.1%, resulting in well-formed products free from deformation or warping due to shrinkage, further enhancing production yield. From mass production of LED encapsulation parts to molding of earphone sleeves and eyeglass nose pads, this silicone integrates smoothly into various production lines with simple proportioning and fast curing. It greatly boosts production efficiency and saves enterprises substantial time and labor costs.