In mold making, three common pain points are complex mixing ratio, difficult demolding, and easy bubble formation. Either incorrect ratio leads to mold non-curing, or mold sticking causes product damage during demolding, or excessive bubbles affect mold precision. Especially for beginners, it is easy to step on pitfalls. A high-transparency mold silicone, with the advantages of simple 10:1 weight ratio, excellent demoldability and easy operation, makes the entire mold making process worry-free. It can be easily used whether it is small-batch manual DIY production or professional large-scale production. Its operational convenience meets the needs of various makers. It adopts a 10:1 weight ratio mixing of A and B two components, no complex calculation or conversion is needed, only accurate weighing is required. Even beginners who have just come into contact with mold making can quickly master the ratio skills, completely avoiding operational errors caused by complex ratios. After mixing, stir fully in the same direction, combined with vacuum defoaming treatment, then hold the colloid high and pour it slowly into the same position of the master mold. The colloid can flow and level naturally, minimizing the generation of bubbles, solving the problem of easy bubbling of high-viscosity materials, and ensuring the mold surface is smooth and free of bubble defects. Demoldability is another major advantage. After curing, the mold surface is smooth and non-sticky. Whether pouring AB water, PU material, epoxy resin or polyester resin, the product can be easily demolded after molding, without product texture damage or surface scratches caused by mold sticking, greatly improving the product qualification rate. If you want to speed up the production progress, you can also accelerate the silicone curing speed by heating, flexibly adapting to different production rhythms. For small details in production, there are also thoughtful operation tips. For example, after making the mold frame with 502 glue, wait for half an hour or bake at 50℃ for 10 minutes before pouring the glue, which can avoid colloid poisoning and non-curing, and beginners can easily avoid operational pitfalls. At the same time, this silicone has an operation time of up to 60±10 minutes, providing sufficient time to complete the pouring operation of complex molds. Even molds with multiple fine lines can be made calmly. From DIY small molds for resin jewelry to professional molds for precision machinery, this silicone can be perfectly adapted. With simple operation and excellent molding effect, it makes mold making get rid of tediousness and pitfalls.